Daikin error codes
What the codes on your Daikin warmtepomp mean (Altherma 3, Altherma hybride), what you can safely do yourself and when you need an engineer.
Where do you see the code?
The fault code is on the control module, often a letter and a digit, for example 7H or U4.
Reset
Turn the heat pump off and on again via the controls. For an outdoor unit fault it sometimes helps to switch off its circuit for a few minutes.
All codes
- U0Refrigerant shortageThe heat pump detects too little refrigerant or too low a pressure in the cooling circuit. That may indicate a leak.Engineer needed
- U4No connection between indoor and outdoor unitThe indoor unit can't reach the outdoor unit. Sometimes after a power cut, sometimes due to a cable or circuit board fault.Engineer needed
- 7HToo little water flowToo little water is flowing through the heat pump. Often due to air, a dirty filter, low pressure or closed valves.Often fixable yourself
Questions about Daikin
How do I reset my Daikin warmtepomp?
Turn the heat pump off and on again via the controls. For an outdoor unit fault it sometimes helps to switch off its circuit for a few minutes.
Where is the fault code shown on my Daikin?
The fault code is on the control module, often a letter and a digit, for example 7H or U4.
Which Daikin faults can I fix myself?
7H (too little water flow): the page for each code lists the steps you can safely do yourself.
Checked in 11-2026. Codes can differ per model; if in doubt, check the manual of your appliance.