Vaillant cv-ketel
Fault F.20: overheating
The safety thermostat has tripped: the water in the boiler got too hot. Often due to poor flow, air or a closed valve.
Do this first
- Open all radiator valves.
- Check the water pressure and bleed the radiators.
- Let the boiler cool down and press reset once.
When should you call an engineer?
If the boiler goes to F.20 again, switch it off and call an engineer.
Reset
Press the reset button once (on most ecoTEC models the button with the arrows or 'reset'). If the boiler goes into fault again, don't keep resetting but call an engineer.
Still under warranty?
Add your cv-ketel to your home file, with the installation date. Then you'll see whether it's still under warranty and get a reminder for servicing.
Add applianceFrequently asked questions
What does F.20 mean on a Vaillant cv-ketel?
The safety thermostat has tripped: the water in the boiler got too hot. Often due to poor flow, air or a closed valve.
Can I fix F.20 myself?
Open all radiator valves. Check the water pressure and bleed the radiators. Let the boiler cool down and press reset once. If the boiler goes to F.20 again, switch it off and call an engineer.
Other Vaillant codes
- F.22 too little water in the boiler
- F.28 ignition failed
- F.29 flame goes out while burning
- F.75 no pressure difference when the pump starts
- F.00 flow sensor interrupted
- F.01 return sensor interrupted
- F.10 flow sensor short circuit
- F.27 flame detected while the gas valve is closed
- F.61 fault in the gas valve control
- F.62 gas valve closes too slowly
- F.63 memory error (eeprom)
- F.64 fault in electronics or sensor
- F.73 pressure sensor signal too low
- F.83 dry firing at burner start
Checked in 11-2026. Codes can differ per model; if in doubt, check the manual of your appliance.