Vaillant cv-ketel
Fault F.27: flame detected while the gas valve is closed
The boiler sees a flame signal while no gas should be burning. That points to a fault in the gas valve or flame monitoring.
Do this first
- Turn the boiler off.
- Smell gas? Don't touch any switches, open windows and doors, go outside and call 0800-9009 (the national emergency number for gas and power).
When should you call an engineer?
Leave the boiler off and call an engineer. This is a safety fault.
Reset
Press the reset button once (on most ecoTEC models the button with the arrows or 'reset'). If the boiler goes into fault again, don't keep resetting but call an engineer.
Still under warranty?
Add your cv-ketel to your home file, with the installation date. Then you'll see whether it's still under warranty and get a reminder for servicing.
Add applianceFrequently asked questions
What does F.27 mean on a Vaillant cv-ketel?
The boiler sees a flame signal while no gas should be burning. That points to a fault in the gas valve or flame monitoring.
Can I fix F.27 myself?
Turn the boiler off. Smell gas? Don't touch any switches, open windows and doors, go outside and call 0800-9009 (the national emergency number for gas and power). Leave the boiler off and call an engineer. This is a safety fault.
Other Vaillant codes
- F.22 too little water in the boiler
- F.28 ignition failed
- F.29 flame goes out while burning
- F.75 no pressure difference when the pump starts
- F.20 overheating
- F.00 flow sensor interrupted
- F.01 return sensor interrupted
- F.10 flow sensor short circuit
- F.61 fault in the gas valve control
- F.62 gas valve closes too slowly
- F.63 memory error (eeprom)
- F.64 fault in electronics or sensor
- F.73 pressure sensor signal too low
- F.83 dry firing at burner start
Checked in 11-2026. Codes can differ per model; if in doubt, check the manual of your appliance.