Vaillant cv-ketel
Fault F.73: pressure sensor signal too low
The signal from the water pressure sensor is too low: the sensor or the cable is faulty, or there's a short circuit.
Do this first
- Check the water pressure on the gauge.
- Press reset once.
When should you call an engineer?
An engineer has to replace the pressure sensor or the cable.
Reset
Press the reset button once (on most ecoTEC models the button with the arrows or 'reset'). If the boiler goes into fault again, don't keep resetting but call an engineer.
Still under warranty?
Add your cv-ketel to your home file, with the installation date. Then you'll see whether it's still under warranty and get a reminder for servicing.
Add applianceFrequently asked questions
What does F.73 mean on a Vaillant cv-ketel?
The signal from the water pressure sensor is too low: the sensor or the cable is faulty, or there's a short circuit.
Can I fix F.73 myself?
Check the water pressure on the gauge. Press reset once. An engineer has to replace the pressure sensor or the cable.
Other Vaillant codes
- F.22 too little water in the boiler
- F.28 ignition failed
- F.29 flame goes out while burning
- F.75 no pressure difference when the pump starts
- F.20 overheating
- F.00 flow sensor interrupted
- F.01 return sensor interrupted
- F.10 flow sensor short circuit
- F.27 flame detected while the gas valve is closed
- F.61 fault in the gas valve control
- F.62 gas valve closes too slowly
- F.63 memory error (eeprom)
- F.64 fault in electronics or sensor
- F.83 dry firing at burner start
Checked in 11-2026. Codes can differ per model; if in doubt, check the manual of your appliance.