Vaillant cv-ketel
Fault F.83: dry firing at burner start
When the burner starts, the flow or return temperature changes too little. Usually too little water in the boiler, or air.
Do this first
- Check the water pressure and top up to 1.5 to 2 bar.
- Bleed the radiators.
- Press reset once.
When should you call an engineer?
If F.83 keeps coming back with good pressure, have the pump and the sensors checked.
Reset
Press the reset button once (on most ecoTEC models the button with the arrows or 'reset'). If the boiler goes into fault again, don't keep resetting but call an engineer.
Still under warranty?
Add your cv-ketel to your home file, with the installation date. Then you'll see whether it's still under warranty and get a reminder for servicing.
Add applianceFrequently asked questions
What does F.83 mean on a Vaillant cv-ketel?
When the burner starts, the flow or return temperature changes too little. Usually too little water in the boiler, or air.
Can I fix F.83 myself?
Check the water pressure and top up to 1.5 to 2 bar. Bleed the radiators. Press reset once. If F.83 keeps coming back with good pressure, have the pump and the sensors checked.
Other Vaillant codes
- F.22 too little water in the boiler
- F.28 ignition failed
- F.29 flame goes out while burning
- F.75 no pressure difference when the pump starts
- F.20 overheating
- F.00 flow sensor interrupted
- F.01 return sensor interrupted
- F.10 flow sensor short circuit
- F.27 flame detected while the gas valve is closed
- F.61 fault in the gas valve control
- F.62 gas valve closes too slowly
- F.63 memory error (eeprom)
- F.64 fault in electronics or sensor
- F.73 pressure sensor signal too low
Checked in 11-2026. Codes can differ per model; if in doubt, check the manual of your appliance.